Publicidad
Idiomas disponibles
Idiomas disponibles
To check the setting
Press [SETUP] repeatedly to select "TIMER ADJ" and
then press [OK].
In standby mode, press [DISPLAY] two times.
Note:
•
The timer starts at a low volume and increases gradually to
the preset level.
•
The timer comes on at the set time every day if the timer is
on.
•
If you switch off the system and then switch on again while a
timer is in operation, the timer will not stop at the end time.
• "
"
"
"
"
"
CD
,
USB
,
DAB+
and
source.
Sound effects
1
Press [SOUND] repeatedly to select the sound
effect.
2
Press [R, T] to select the setting and then press
[OK].
MY SOUND
"SOUND 1", "SOUND 2" or
"SOUND 3" (
PRESET EQ
"HEAVY", "SOFT", "CLEAR",
"VOCAL" or "FLAT"
BASS
–4 to +4
TREBLE
–4 to +4
D.BASS
"ON D.BASS" or "OFF D.BASS"
SURROUND
"ON SURROUND" or
"OFF SURROUND"
Note:
Changed settings will be kept until it is changed again, unless
otherwise indicated.
Saving the sound settings
You can save the current sound effects (up to
3 combinations).
Preparation
Select the sound effects.
1
Press [SETUP] to select "SAVE MY SOUND".
2
Press [R, T] to select a sound setting number and
then press [OK].
"SAVED" is shown.
The new setting replaces the one existing in the same
sound setting number.
To recall the setting
1
Press [SOUND] to select "MY SOUND".
2
Press [R, T] to select the sound setting number
and then press [OK].
"
"
FM
can be set as the music
below)
Others
Auto off
This function will automatically switch the unit to standby
mode if there is no sound and it is not being used for
approximately 20 minutes.
1
Press [SETUP] repeatedly to select "AUTO OFF".
2
Press [R, T] to select "ON" and then press [OK].
To cancel, select "OFF".
Note:
•
This function does not work when you are in radio source or
when a Bluetooth
device is connected.
®
•
The factory default is "ON". To switch off this function, select
"OFF".
Bluetooth
standby
®
This function automatically switches on the system when
you establish a Bluetooth
®
device.
1
Press [SETUP] repeatedly to select
"BLUETOOTH STANDBY".
2
Press [R, T] to select "ON" and then press [OK].
To cancel, select "OFF".
Software update
Occasionally, Panasonic may release updated software
for this unit that may add or improve the way a feature
operates. These updates are available free of charge.
For more details, refer to the following website.
http://panasonic.jp/support/global/cs/
(This site is in English only.)
█ Checking the software version
1
Press [SETUP] repeatedly to select "SW VER."
and then press [OK].
The software version is shown.
2
Press [OK] again to exit.
connection from a paired
11
11
Publicidad
