Panasonic SC-HC212 Instrucciones De Funcionamiento página 6

Preparing the media
Disc
1
Press [USB/CD] to select "CD".
2
Press [CD x] (main unit: [x]) to open the sliding
door.
Put in a disc with the label facing towards you.
3
Press [CD x] (main unit: [x]) again to close the
sliding door.
Keep fingers away from the sliding door when it is
closing.
USB
USB device
(not supplied)
Press [USB/CD] to select "USB".
Note:
Do not use a USB extension cable. The system cannot
recognise USB device connected through a cable.
Bluetooth
®
You can connect and play an audio device wirelessly
through Bluetooth .
®
Preparation
• Switch on the unit.
• Switch on the Bluetooth
the device near the system.
• Read the operating instructions of the device for details.
6
6
feature of the device and put
®
█ Pairing a device
Preparation
If this system is connected to a Bluetooth
disconnect it. ( below)
1
Press [ ] to select "BLUETOOTH".
If "PAIRING" is shown, continue with step 3.
2
Press [PLAY MENU] to select "PAIRING" and then
press [OK].
Or press and hold [
"PAIRING" is shown.
3
Select "SC-HC212" from the Bluetooth
the device.
If prompted for a passkey, input "0000".
The device connects with this system automatically
after pairing is complete.
The MAC address (example: 6C:5A:B5:B3:1D:0F)
may be shown before "SC-HC212" is shown.
The name of the connected device is shown for a few
seconds.
Note:
You can pair up to 8 devices with this system. If a 9th device is
paired, the device that has not been used for the longest time
will be replaced.
█ Connecting a device
Preparation
If this system is connected to a Bluetooth
disconnect it. ( below)
1
Press [ ] to select "BLUETOOTH".
"BLUETOOTH READY" is shown.
2
Select "SC-HC212" from the Bluetooth
the device.
The name of the connected device is shown for a few
seconds.
3
Start playback on the device.
Note:
•
A device must be paired to connect.
•
This system can only connect to one device at a time.
•
When "BLUETOOTH" is selected as the source, this system
will automatically try to connect to the last connected device.
("LINKING" is shown during this process.)
█ Disconnecting a device
1
Press [ ] to select "BLUETOOTH".
2
Press [PLAY MENU] repeatedly to select
"DISCONNECT?".
3
Press [R, T] to select "OK? YES" and then press
[OK].
Note:
A device is disconnected when you:
•
Select a different source.
•
Move the device out of the maximum range.
•
Disable the Bluetooth transmission of the device.
®
•
Switch off the system or the device.
device,
®
–PAIRING] on the main unit until
menu of
®
device,
®
menu of
®