Polar UNIVERSAL LOADING CHARGER LOG Instrucciones De Uso Para El Usuario página 24

Once the start time of the charging or delayed start
has been set, connect the battery to the charger.
Then the scheduled time for the start of charging
will appear on the screen.
The actual start delay will always be the last one set.
To reset and cancel programmed start to charge settings, both set up of start time
to charge and delay charge start, when you see "No Battery '' press
the Delayed Start setup menu.
Then press
e
Use to set the time to 00:00.
This procedure will reset and cancel both of delayed start settings.
U.L.C. LOG chargers are equipped with internal data backup for each charge made.
The data storage function is not active when the charger is programmed
with the 'Desulf' curve.
To download the data, you need to use the provided USB flash drive and insert it into
the appropriate connector on the front panel of the charger, see pp.2-3.
Turn on the charger with the battery
not connected and wait until you'll see
"No battery".
Unscrew the USB connector cover located on the front panel of the charger.
Insert the USB flash drive into the connector. After the standby screen, the save data
confirmation screen appears.
e
Press to start of download,
e
otherwise press
e
After pressing
When saving is complete, the display shows the initial
standby screen - "No battery".
At this point, it is possible to disconnect the USB flash.
10.24.42
No
Battery
again to enter the delay time setting menu.
SAVING LOG DATA
to cancel.
data downloading starts.
ATTENTION!
Start at:
Time: 12.56
Setting 10.24.46
Delayed Start
+ : Set Time
- : Set Delay
10.26.14
to enter
10.24.42
No
Battery
23.