cecotec CONGA 12090 TWICE ROLLER HOME&FILL Manual De Instrucciones página 69

If you clean the water tank regularly every day, and the cleaning surface is smaller than 60 m
it is enough to add water up to the MIN mark each time.
5. After adding water, close the top cover of the water tank, secure the water-tank lock tab,
and place the water tank back in the self-emptying base.
Note:
- Do not add hot water to the clean-water tank to avoid deformation of the tank.
- If you notice water stains on the outside of the water tank, wipe them with a soft, dry cloth
before resuming use.
- Do not use cleaning agents to prevent damage to the robot vacuum cleaner and self-
emptying base.
Self-emptying base
Infrared sensors
Check if the infrared lens and the charging terminals of the self-emptying base are dirty, and
wipe them with a clean, dry cloth to clean them if necessary. Fig. 29
Note:
It is recommended to clean both at least once a month.
Filter holder
Check the filter holder for lint or dirt build-up and remove it by wiping it with a clean, dry cloth.
Fig. 30
Note:
It is recommended to clean both at least once a month.
Removing the battery
Chemical substances contained in the battery of the appliance may pollute the environment:
remove it before disposing of the robot vacuum cleaner and take it to a collection point
designated by local authorities.
1. Let the robot vacuum cleaner run until the battery is low and it can no longer clean. Turn
the self-emptying base off to prevent the robot to return to it.
2. Hold down the power button to turn the robot vacuum cleaner off.
3. Remove the mixed tank from the robot vacuum cleaner and turn it upside down.
4. Remove the side brush and remove the screws from the cover on the body.
5. Remove the cover from the body. Fig. 31
6. Unplug the battery connector and remove the battery.
CONGA 12090 TWICE ROLLER HOME&FILL
ENGLISH
,
2
69