Publicidad
Problems
Motor stops
Motor starts but
no pressure
Pressure pulsating
Probable causes
Fuse faulty / blown
Wrong mains voltage
Motor protector has
activated
The plug has been
disconnected
The motor is out of
service
Nozzle partly blocked
Low pressure nozzle
selected
Water inlet pressure is
too low
The pump is blocked
Water filter blocked
The pump sealing is
damaged
Air in the inlet water
supply hose (espacially
by self priming funciton)
Low pressure nozzle
selected
Water filter blocked
Water hose squeezed
207
Solutions
Replace fuse
Check that mains
voltage corresponds to
the specifications
Wait to cool for 15min
and try again
Reconnect the plug
Contact the after sales
service
Clean it
Change the nozzle
selection
Check the inlet
pressure specification
Contact the after sales
service
Clean it
Contact the after sales
service
Remove the air from
the hose
Change the nozzle
selection
Clean it
Straighten out kinked
water supply hoses
Qualification
Customer
Customer
Customer
Customer
After Sales
Customer
Customer
Customer
After Sales
Customer
After Sales
Customer
Customer
Customer
Customer
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN
Publicidad
