RIDGID R4021SN Manual Del Operador página 14

ASSEMBLY
INSTALLING THE SPLASH HOOD
See Figure 10.
 Remove the bevel table.
 Using a Phillips screwdriver, loosen and remove the three
screws located on the pocket under the table behind the
cutting wheel.
 Slide the L-shaped splash hood bracket into the pocket.
 Reinstall the screws through the splash hood bracket and
into the table. Tighten securely.
NOTE: Align the hood bracket with the cutting wheel so
that it does not interfere with the material being cut. To
check the alignment, see Splash Hood Bracket Adjust-
ment in the Adjustments section of this manual.
NOTE: Always adjust the splash hood horizontally to the
table and slightly above tile thickness. Hood should not
touch the tile.
 To lift or lower the splash hood or adjust its position,
loosen the lock knob, adjust the splash hood to the de-
sired height, and retighten the lock knob.
 Reinstall the bevel table.
INSTALLING THE RIP GUIDE
See Figure 11.
 Place the front of the rip guide on the front rail of the saw
table.
 Lower the back of the rip guide to the saw table.
 Use the rip guide scale, located on front of the table, to
set the rip guide to the desired width of cut.
 Push the locking lever down to secure to the saw table.
When securely locked, the locking lever should point
downward.
ASSEMBLING THE STAND
See Figure 12.
TOOLS NEEDED: Adjustable wrenches or 13 mm wrenches
NOTE: Support brackets and stand legs are numbered to
correspond with the instructions. The numbers on the stand
legs should match the numbers on the support brackets.
ITEM
"L" Support bracket .................................................1
Tube Support bracket ..............................................1
Stand leg 1 ...............................................................2
Stand leg 2 ...............................................................2
Bolt ...........................................................................2
Washer .....................................................................4
Spacer ......................................................................2
Nut ............................................................................2
SPLASH
HOOD
LOCK
KNOB
RIP
GUIDE
QTY.
NOTE: The Tube support bracket has a rounded crosspiece.
The "L" Support bracket has a right angle crosspiece.
 Insert stand leg 1 into the "L" support bracket. Insert stand
leg 2 into the same side of the Tube support bracket.
NOTE: Angled ends of stand legs should face away from
each other so they resemble a "V". The foot of each stand
leg should point outward.
14 — English
SPLASH HOOD
SCREWS
BRACKET
POCKET
Fig. 10
LOCKING
LEVER
Fig. 11