RIDGID R4021SN Manual Del Operador página 16

ASSEMBLY
ASSEMBLING THE SAW TO THE STAND
See Figure 13.
 Place stand on level ground and line up grooves under
the tile saw table with the supports on the stand. Carefully
set the saw onto the stand.
NOTE: It may be easier to fit the saw onto the stand if the
stand is not opened fully. Slightly tilt one side of the saw
as you set it onto the stand. Ease the other side of the
saw down until it sits on the stand and allow the stand
to open as the saw is fully seated.
 Be sure the tile saw is on level ground and the stand is
stable before use.
 When the stand is not in use, it may be folded for storage.
GROOVES
16 — English
Fig. 13