Troy-Bilt LS 27 TB Manual Del Operador página 7

Assembly & Set-Up
Contents of Carton
• One Log Splitter
• One Tongue Assembly
WARNING!
Use extreme caution when unpacking
this machine. Some components are very heavy and
will require additional people or mechanical
handling equipment.
NOTE: All references in this manual to the left or right side of the
log splitter are from the operating position only. Exceptions, if
any, will be specified.
Assembly
Attaching the Jack Stand
The jack stand is shipped in the transport position.
1. Remove the spring clip and clevis pin and then pivot the jack
stand towards the ground into the operating position.
2. Secure the jack stand in position with the clevis pin and
spring clip. See Fig. 3-1.
Clevis Pin
Figure 3-1
• One Operator's Manual
Attaching the Tongue
1.
Spring Clip
2.
Jack Stand
• One Engine Operator's Manual
With the log splitter still standing upright, remove the two
hex bolts and hex nuts from the tank bracket. See Fig. 3-2.
Tongue
Hex Nuts
Hex Bolts
Figure 3-2
Align the holes in the tongue with the holes in the tank
bracket and secure with the hardware just removed. See
Fig. 3-2.
NOTE: The high pressure hose, which runs from the gear
pump the the bottom of the control valve, must be above
the tongue assembly. See Section 9 (Illustrated Parts List) if
you are unsure of which hose is the high pressure hose.
3
Tank Bracket
7