Husqvarna 525HF3S Manual De Usuario página 6

2. Make sure that the throttle trigger is locked at the
idle position when the throttle trigger lockout is
released.
3. Push down the throttle trigger lockout and make
sure that it goes back to its initial position when you
release it.
4. Start the product. Refer to
page 10 . Apply full throttle.
5. Release the throttle trigger and make sure that the
blades stop and stay stationary.
WARNING:
when the throttle trigger is in the idle
position, then the carburetor idle speed
must be adjusted. Refer to
idle speed on page 12 .
To do a check of the stop switch
1. Start the engine.
2. Move the stop switch to the stop position and make
sure that the engine stops.
6
To start the engine on
If the blades move
To adjust the
To do a check of the hand guard
The hand guard prevents injuries from the blades.
1. Stop the engine.
2. Make sure that the hand guard is attached correctly.
3. Examine the hand guard for damages.
To do a check of the vibration damping system
WARNING:
cord or an incorrect cutting attachment
increases the level of vibration.
The vibration damping system decreases vibration in
the handles to a minimum which makes the operation
easier. The vibration damping system decreases the
vibrations between the engine unit and the shaft unit.
1. Stop the engine.
2. Do a visual check for deformation and damage, for
example cracks.
3. Make sure that the vibration damping units are
attached correctly.
Use of incorrectly wound
1118 - 005 - 29.08.2023