Publicidad
Idiomas disponibles
Idiomas disponibles
When everything is connected:
1
Press the 'menu' button on Blackmagic Web Presenter to open the LCD menu and navigate
to the 'live stream' menu.
2
Select the ATEM Streaming Bridge in the 'platform' setting.
3
Press 'set' to confirm.
For tally to work, you need to make sure the camera has the ATEM camera ID set to match the
input on the switcher. For information on how to set the ATEM Camera ID, refer to the URSA
Mini manual.
You can test that tally is working by switching the camera to the program output on the ATEM
switcher. If the ATEM camera ID is set correctly on your camera, you will see the tally light
illuminate including a red tally border around the camera's LCD. Now switch the camera to the
preview output and the tally will illuminate green.
Try adjusting the iris and pedestal in ATEM Software Control's camera page to test camera control.
Embedded SDI audio channels 15 and 16 are set as the default talkback channels but you can
change them to engineering channels 13 and 14, or the program output using the ATEM
Setup utility.
When transmitting over the Internet, an XML setup file is created using the ATEM Setup utility.
This XML file is then loaded into Blackmagic Web Presenter so it can find the ATEM Streaming
Bridge on the Internet. For more information on how to create and load the setup XML file, refer
to the previous section in this manual.
Connecting URSA Broadcast G2
URSA Broadcast G2 has a built in streaming engine which means you don't need to use a
Blackmagic Web Presenter as the camera can stream directly from its USB-C expansion port.
Refer to the URSA Broadcast G2 manual for more information, including how to set the ATEM
camera ID so tally works correctly.
Tally, Talkback and Camera Control
27
Publicidad
