Publicidad
Idiomas disponibles
Idiomas disponibles
Mounting a Unit to the Rack Shelf
1
If rubber feet are attached, remove the feet from the base of the unit using a plastic edged
scraping tool.
2
With both the rack shelf and the unit upside down, line up the rack shelf's pre drilled holes
with the threaded mounting holes on the base of the Blackmagic Design unit. There are two
central mounting points on 1/3 width units and up to three mounting points on larger, 1/2
rack width units.
3
Using the supplied M3 5mm countersunk screws, fasten the unit to the rack shelf.
4
Once fastened, turn the rack shelf right side up and install into the rack via the built in
rack ears.
The supplied blanking panels can be used to cover unused shelf space.
Attaching the 1/6 Blanking Panel
The small 1/6 blanking panel can be used to fill unused shelf space when mounting 1/2 and
1/3 rack width units. The panel can be attached to the sides of either unit. To improve airflow
it's a good idea to mount the panel between units.
1
Remove the 5mm M3 screw near the front of the unit
Attaching the Side 1/3 Width Blanking Panel
The large 1/3 width blanking panels can be attached directly to either side of the rack shelf
when mounting single units. To install a blanking panel, align the screw holes and anchor point
at the base of the panel with the shelf and secure in place using two of the supplied M3 5mm
countersunk screws.
2
Line up the blanking panel and attach using
the supplied M3 9mm nylon screw
Blackmagic Universal Rack Shelf
29
Publicidad
