Descargar Imprimir esta página

Berner BACC-7,2-18V Li-Ion/NiCd/Ni-MH Instrucciones De Manejo/Instrucciones De Seguridad página 14

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 23
Read instruction manual before use.
Battery charging.
Battery charged.
Battery defective.
Hot/cold pack delay.
Do not probe with conductive objects.
Do not charge damaged battery packs.
Use only with Berner battery packs, others may
burst, causing personal injury and damage.
Do not expose to water.
Have defective cords replaced immediately.
Charge only between 4 °C and 40 °C.
Discard the battery pack with due care for the
environment.
Do not incinerate the battery pack NiMH,
NiCd+ and Li Ion.
Charges NiMH and NiCd battery packs.
Charges Li-Ion battery packs.
See technical data for charging time.
DATE CODE POSITION
Date Code, which also includes the year of manufacture,
is printed into the housing base below the rating label!
Example:
2007 XX XX
Year of Manufacture
Chargers
Be sure to read all safety instructions before using your
charger.
Charging Procedure
DANGER: Electrocution hazard. 230 volts
present at charging terminals. Do not probe
with conductive objects. Danger of electric
shock or electrocution.
1. Plug the charger into an appropriate outlet before
inserting battery pack.
2. Insert the battery pack into the charger. The red
(charging) light will blink continuously indicating that
the charging process has started.
3. The completion of charge will be indicated by the red
light remaining ON continuously. The pack is fully
charged and may be used at this time or left in the
charger.
Charging Process
Refer the table below for the state of charge of the
battery pack.
State of charge
charging
fully charged
hot/cold pack delay
replace battery pack
problem
Automatic Refresh
The automatic refresh mode will equalise or balance the
individual cells in the battery pack at its peak capacity.
Battery packs should be refreshed weekly or whenever
the pack no longer delivers the same amount of work.
To refresh your battery pack, place the battery in the
charger as usual. Leave the battery pack for at least 8
hours in the charger.
Hot/Cold Pack Delay
When the charger detects a battery that is too hot or
too cold, it automatically starts a Hot/Cold Pack Delay,
suspending charging until the battery has reached an
appropriate temperature. The charger then automatically
switches to the pack charging mode. This feature
ensures maximum battery life.
DEEP DISCHARGE PROTECTION
The battery pack is protected against deep discharging
when it is used in the tool.
13
E N G L I S H
– – – – – –
–––––––––––
––– – ––– –
•••••••••••
•• •• •• ••

Publicidad

loading

Este manual también es adecuado para:

057546