Descargar Imprimir esta página

ELICA ENF430BL Guía De Instalación, Uso Y Mantenimiento página 9

Publicidad

Idiomas disponibles

Idiomas disponibles

TOP INSTALLATION
1.
Turn the cooktop upside down on a protective cover.
2.
Apply adhesive foam seal around the glass overhang,
5mm from the edge of the glass. Ensure the adhesive
side facing is down to form a continuous seal around the
cooktop.
3.
Trim the excess sealing material using a sharp cutter or
trimmer knife. Take care not to damage the benchtop.
4.
Install the transition on the bottom of the plate, make
sure that the transition flaps are on the outside and push
it to the bottom. Secure it with 2 screws (4.2 x 8 mm)
5.
Attach the four side clips to the cooktop chassis. Make
sure the clips are oriented correctly, press the center tab
with a flat screwdriver to pass the clip through and secu-
re against the plate..
6.
Lift the cooktop and place it in the center by dropping
carefully both sides of the grill at the same time.
7.
Clean the cooktop with a cloth.
5mm
FLUSH INSTALLATION
1.
Prepare the countertop for flush installation. Use a router
to cutout the edges of the countertop to specified depth
(.63cm). Ensure all bare edges are sealed.
2.
Turn the cooktop upside down on a protective cover &
apply adhesive foam seal around the glass overhang,
5mm from the edge of the glass. Ensure the adhesive
side facing is down to form a continuous seal around the
cooktop.
3.
Install the transition on the bottom of the plate, make
sure that the transition flaps are on the outside and push
it to the bottom. Secure it with 2 screws (4.2 x 8 mm)
4.
Place tape over the transition joint to prevent air from
escaping.
5.
Attach the four side clips to the cooktop chassis. Ensure
the clips are oriented correctly, press the center flap of
the clip to pass through and secure.
6.
Lift the cooktop and place it in the center by dropping
carefully both sides of the grill at the same time.
7.
If necessary, spacers should be installed to adjust the size
of the plate to the space.
8.
Apply silicone in the gap between countertop and cook-
top. Wipe off any excess silicone.
9.
Clean the cooktop carefully with glass cleaner and a
cloth.
9
5mm

Publicidad

loading

Este manual también es adecuado para:

Enf436bl