Epson TM-L90-i Manual Del Usuario página 12

WARNING:
If an accident occurs with the power button cover attached, unplug the AC
cable immediately. Continued use may cause fire or shock.
Installing the Printer
You can install this printer horizontally (with the paper exit on top) or vertically
(with the paper exit at the front) on a flat surface. Both the horizontal and vertical
positions are shown in illustration
When you install the printer horizontally, attach the control panel label shown in
illustration
E
illustration
F
Loosen the screw (F 9) with a coin or similar tool and turn it at least 3 or 4
1.
times.
2. Turn the lever (F 8) to move the sensor in the direction of the arrow in
illustration
bottom of the printer.
3. Tighten the screw and make sure the lever moves smoothly.
Note:
You cannot use the optional wall hanging bracket set WH-10.
Changing the Paper Width
This printer accommodates 80 mm wide roll paper with no adjustments. For rolls
from 38 mm to 70 mm wide, use the roll paper spacer included with the printer. (If
the rolls are from 61 to 70 mm wide, break two tabs (G 12) off the back of the roll
paper spacer. (You can still use widths from 38 mm to 60 mm with the roll paper
spacer with the tabs broken off.) Follow the steps below to attach the roll paper
spacer.
1. Open the roll paper cover.
Insert the roll paper spacer (H 15) so that the front edge (H 14) goes through
2.
the notch (H 13); then push down the spacer so that the hook (I 16) on the
spacer and the shaft align.
3. Push the roll paper spacer until you feel it clicks onto the shaft (I 17). Check
that the roll paper spacer slides smoothly to the left and right.
4. Slide the roll paper spacer to the appropriate width. You can use the ruler
(I 20) printed inside the printer, aligning the inside edge (I 19) of the spacer
with the desired measurement.
5. Tighten the spacer with the screw (I 18) included with the spacer as shown in
illustration I. (Although there are two holes, this is the only one to put the
screw in.)
Notes on Changing the Paper Type
This printer is set to use the paper layout for the bundled label roll paper (or receipt
paper). In some cases, changing the paper type may cause an error. Follow the steps
below to fix the error and set the new paper layout. (When an error occurs, the
ERROR LED flashes twice repeatedly.)
5 TM-L90-i User's Manual
and position the roll paper near-end sensor (F 11) as shown in
. To move the sensor, follow the steps below.
until the sensor comes out from another hole (F 10) near the
F
D.