Publicidad
Idiomas disponibles
Idiomas disponibles
Installing Roll Paper
1.
Lift the cover open lever indicated by the arrow in illustration O and open the roll
paper cover.
2.
Remove the used roll paper core, if any.
3.
Install the roll paper in the correct direction, as shown in illustration P.
4.
Pull out some roll paper, as shown in illustration Q, so that the paper is set
between the paper guides (Q 30).
5.
Close the roll paper cover and tear off the roll paper, as shown in illustration
R.
Note:
Be sure to use the roll paper that meets the specifications.
Test Printing
After the printer setup or when the printer is not operating correctly, you can
check the printer operation with test printing. If the printer performs pattern
printing when you follow the steps below, the printer is operating normally.
1.
Make sure the paper is correctly inserted and all the covers are closed.
2.
While pressing the FEED button, turn the printer on.
After the printer prints its status and the PAPER OUT LED flashes, press the
3.
FEED button again to restart the test printing.
The test printing is completed when "*** completed***" is printed.
About Network Connection
Confirming the Network Settings
Make sure the printer is turned on, press the push button (S 31) at the interface part for
approximately 3 seconds. When you release the button, a status sheet on which network
parameters are printed will be ejected.
With the status sheet, you can check all the settings necessary for connecting to the network.
Note:
If you keep pressing the button for more than 10 seconds, the network settings are
initialized. (See "Initializing the Network Setting" on page 8.)
The printer is initially set so that the IP address for the wired LAN will be obtained by
DHCP. When you turn on the printer, the IP address is obtained and then it will be
printed out automatically.
Network Setting
Make the same settings on the computer and access points as those printed in the status sheet.
Use the web browser to make the network settings. Input the printer's IP address in an
address bar of the web browser, and make the network settings as directed in TM-L90-i
Technical Reference Guide.
Initializing the Network Setting
To reset the network settings to the default values, press the push button (S 31) at
the interface part for more than 10 seconds. When you release the button, the
initialization will be started.
TM-L90-i User's Manual 8
Publicidad
