Publicidad
Idiomas disponibles
Idiomas disponibles
Generac Portable P roducts 2,400 PSI H igh Pressure Washer
IMPORTANT:
Read entire owner's manual before you
attempt to assembleor operate your new pressure washer.
REMOVE
PRESSURE
WASHER
FROM
CARTON
• Remove the parts box includedwith pressure washer.
• Slice two corners at the end of carton from top to
bottom so the panel can be folded down fiat, then
remove all packing material.
• Roll pressure washer out of carton.
Carton
Contents
Items in the carton include:
Main Unit
Parts Box (which includesthe following):
Goggles
Handle Assembly
PlasticAccessory Tray
Handle Fastening Hardware (which includes):
Carriage Bolts (2)
Plastic Knobs (2)
"J" Hook
Chemical Hose Clip
Self Tapping Screws (5)
Nozzle Cleaning Kit
High Pressure Hose
Quick Connect
Owner's Manual
Engine Manual
Owner's Registration Card
Spray Gun
Nozzle Extension
Oit Bottle
O-Ring Maintenance Kit
If any of the above parts are missing or damaged, call the
pressure washer helpline at 1-800-270-1408.
PREPARING
PRESSURE
WASHER
FOR USE
If you have any problems with the assembly of your
pressure washer or if parts are missing or damaged, call the
pressure washer helpline at 1-800-270-1408.
To prepare your pressure washer for operation, you
will need to perform these tasks:
• Fitl out and send in registration card.
• Attach accessory tray to handle, then attach handle to
main unit.
• Add oil to engine crankcase.
• Add fuel to fuel tank.
• Connect high pressure hose to spray gun and pump.
• Connect water supply to pump.
Attach
Handle
and Accessory
Tray
NOTE: Alt assembly operations given in this section will
be described from the perspective of assemblingthe
pressure washer from the rear.
• Slide the plastic accessory tray onto the handle and align
the holes in the accessory tray with the holes on the
handle (Figure I).
• Secure tray to handle with self tapping screws using a
#2 phillips screwdriver. Ensure screws are tight but not
crushing the plastic accessory tray.
/
5
Publicidad
