Publicidad
Idiomas disponibles
Idiomas disponibles
Generac Portable P roducts 2,400 PSI H igh Pressure Washer
NOTE: For a warm engine, be sure the choke lever is in
the "Open"
position.
• Move the throttle lever to the "Fast" position, shown
on the engine as a rabbit (Figure 14).
• Placeyour left foot on the lower frame and grasp the
handle as shown (Figure 15). Your unit may appear
slightly different from that shown here.
• Pull the starter grip handle lightly with your right hand
until you feel some resistance, then pull briskly.
• Return the starter grip handle slowly. Do Not let rope
"snap back" against starter.
• When engine starts, slowly move choke lever to the
"Open"
position. If engine falters, move choke lever to
the "Closed"
position, then to the "Open" position.
• If engine fails to start after six pulls, move choke lever to
the "Open"
position. If engine fires, but does not
continue to run, move choke lever to the "Closed"
position, then to the "Open"
position.
NOTE: If the recoil starter is hard to pull, it may be necessary
to squeezethe gun trigger to relieve internalpump pressure.
How
to Stop
Your
Pressure
Washer
• Move throttle lever on engine to "Stop" position.
• Rotate the fuel valve to the "Off" position.
• Squeeze trigger on the spray gun to relieve
pressure in the hose.
NOTE: A small amount of water will squirt out when you
release the pressure.
How to Use Accessory Tray
The unit is equipped with an accessory tray with places to
store your nozzle extension, and slots to hold the cleaning
solution bottle and the detergent siphoning filter. There are
also two hooks at the ends of the accessory tray to hold
your spray gun and high pressure hose.
NOTE: The extra holes in the tray are for storing a brush
and a turbo wand. The brush and turbo wand are NOT
included with your pressure washer. You can buy these
items as optional accessories.
• Place the nozzle extension through the hole on the
accessory tray, as shown in Figure 16.
Hang your chemical solution bottle on the "J" hook and
place the detergent siphoning filter in the last slot on the
left (Figure 16).
• Hang the high pressure hose on the hook on the right
side of the accessory tray (Figure 16).
• Place the spray gun on the hook on the left side of the
accessory tray as shown on page 4.
/
9
Publicidad
