Publicidad
Idiomas disponibles
Idiomas disponibles
Operating Instructions
Stationary Air Compressor
deterioration,
weakness or leakage.
Repair or replace defective items
before using.
8. Check all fasteners at frequent
intervals for proper tightness.
fAWARNINGI
Motors, elet_rkat
errulpmene rand controls
can cause ele_'_cal
ar_r
that will Ignite •
flammable
g_s or vapor. Never operate
or repalr ln or near m flammable
gas or
vapor. Never store
flammable
|lqu|ds
or g._es In the vi¢letty
of the
(omprossor.
Never operase o_mnressor
_ehouea_,_
rhls _vj
I
unit ran steelt automaflr.411Yr"_F"-
I
wlthou_ warning. Penfonal
InJmy or l_,_oerty
d_mDgn could occur
from contact
wfth moving petit.
g, Do not wear Io_e
€lnthing
or
jewelry that will get caught
in the
moving parts of the unit.
c_m_ressor
pmnls my
1_
hot even lf the unls ls
stopped.
10. Keep fingers away from a running
¢ompr_sor;
fast movi_j
and h_t
parrs will cause injury and/or burns.
11. ff the equipment
should start to
vibrate abnormally.
STOP the
engIP_/m_-
and ,thick
immediately
for the cause. Vibration
is generally a warning of trouble.
12.To reduce fire hazard, keep
englne/mofor
exterior free of oil,
solvent, or excessive grease.
_
An _ME
_
s_ry
m_f
valve
wffh a _
no h_ar
_
l_pN
compress-.
_e
._
so_
va/ve
p,_e va_s _e_h/p, t e,.e_me_e
mu/mum
eperoffng
_,
13. Never attempt
to adjust ASME
safe'_ "_a_. Keep sefaty valve free
from paint and other a_cumulatiom.
LAWARNINGI
Nem-,,_ ._.,_
pvc:_ p_ f_-
€ompressed a/r. S_fous
_n/uty a_
cou/d resu/t.
Never •if•rapt
!o r_palr or
mod|fy a tankl We)dlng,
drilling or _my other
modification
will weaken
the lank
resulting In damage from nJpture or
expfosfo_
Afw•_
replace
_rlcked
or damaged
tenk_
Drain liquid from
tank dally.
14.Tanks
rust from moisture build-up.
which weakens the tank. Make sure
to drain tank regularly and inspect
periodically for unsafe conditions
such as rust formation
and ¢owosion.
15. Fast mo_ng air will stir up dust and
debris which may be harmful. Release
air slowly whefl draining rnots_ure or
depress_,riz"r,g_
compms_x_" sy_em.
SPRAYING
PRECAUTIONS
I_WARNINGI
Do not spray flammable
materl•ls
In vicinity
of
open flame or near
/gnlflen
souses
Indud/ng
the eomprHsor
un/t.
16. DO not smoke when spraying paint,
insecticides, or other flammable
substances.
17. Use a face mask/
respirator when
spraying and spray in a
well ventilated
area _o
prevent
health and fire
hazards.
18. Donot direct paint or other
sprayed material at the compressor.
Locate compressoras far away from
the spraying area as possibleto
minimize overspray accurnulaUon
on the compressor.
19.When spraying or cleaning with
solventsor toxic chemicals,follow
the instructionsprovided by the
chemical manufacturer.
Refer to Figure 2.
INSTAULING A SHUT-OFF VALVE
A shut-off valve should be Installed on
the discharge port of the tank to
control the air flow out of the tank.
The valve should be located between
the tank and the piping system.
Pressure swltch - Auto/Off Switch - In
the =auto" position, the compressor
shuts off automatically when tank
pressure reaches the maximum preset
pressure. After air Is used from the
tank
and drops to a preset low level.
the pressure switch automatically
turns
the motor back on. In the "off"
position, the compressor will not
operate.
This switch should be in the
"off"
position when connecting or
disconnecting
the power cord from the
electrkal
outlet.
VVhen the pressure switch turns the
motor off you will hear air leaking out
of the pressure switch unloader
valve
for a short time. This releases the air
pressure from the discharge tube and
allows the compressor to restart easier.
For unit3 without
a manua_ switch.
whenever
the procedures call for
turning
the switch to the OFF position,
use the switch at the disconnect
instead.
Unloader
- Device on pressure switch
which allows pressurized air to vent
alleviating
motor restarts under load.
Regulator
- The regulator
controls the
amount
of air pressure released at the
hose outlet (Sold separately).
ASME
Safety
Valve
- This valve
automatically
releases air if the tank
pressure exceeds the preset maximum,
Dlsd_rge
tube
- This tube carries
compressed
air from the pump to the
check valve. This tube becomes very
8eJt Guard
Discharge Tube
auge
_
Tank
Outlet
Tank Drain Val_
rk_z
Publicidad
