Publicidad
Idiomas disponibles
Idiomas disponibles
PRIOR TO USE
1. Clean your refrigerator
thoroughly
and wipe off all
dust that accumulated
during shipping.
2. Install accessories such as ice cube bin, drawers,
shelves, etc., in their proper places. They are packed
together
to prevent possible damage
during shipment.
3. Allow your refrigerator
to run for at least two to three
hours before
putting food in it. Check the flow of
cold air in the freezer compartment
to ensure proper
cooling. Your refrigerator
is now ready for use.
INSTALLATION
The refrigerator
should always be plugged
into its own
individual
properly
grounded
electrical
outlet rated for
115 Volts, 60 Hz, AC only, and fused at 15 or 20 amperes.
This provides the best performance
and also prevents
overloading
house wiring circuits which could cause a fire
hazard from overheated
wires. It is recommended
that a
separate circuit serving only this appliance
be provided.
Shock Hazard:
To reduce the risk of electric
shock, do not install the
refrigerator
in a wet or damp area.
NOTE:
This appliance
is intended
to be used in household and
similar applications
such as:
•
staff kitchen areas in shops, offices and other working
environments
•
farm houses and by clients in hotels, motels and other
residential
environments
•
bed and breakfast
environments
• catering
and similar non-retail
applications.
This product is not to be used for special purposes such
as the storage of medicine or test materials,
or for use
on ships, etc.
INSTALLATION
(continued)
lo
To avoid noise and vibration,
the unit must be
leveled and installed on a solidly constructed
floor. If
required,
adjust the leveling legs to compensate
for
unevenness of the floor. The front should be slightly
higher than the rear to aid in door closing. Leveling
legs can be turned easily by tipping
the cabinet
slightly. Turn the leveling legs clockwise
to raise the unit
or counterclockwise
to lower it. (See LEVELING AND
DOOR ALIGNMENT.)
NOTE: Installing on carpeting,
soft tile surfaces,
a platform
or weakly supported
structure is not
recommended.
o
o
o
Install this appliance
in an area where the temperature
is between 55°F (13°C) and 110°F (43°C). If the
temperature
around the appliance
is too low or high,
cooling
ability
may be adversely
affected.
Select a place where a water supply can be easily
connected
for the automatic
icemaker.
NOTE: The water pressure must be between 20 and
120 psi on models without a water filter and between
40 and 120 psi on models with a water filter.
Too small of a distance from adjacent
items may
result in lowered freezing
capability
and increased
electricity
consumption
charges. Allow at least 24
inches (61 cm) in front of the refrigerator
to open the
doors.
2" (5.08 cm)
10
Publicidad
