Filtration version
The suctioned air will be degreased and deodorised before it is sent back into the room. To use the hood in this version, it is
necessary to install an additional activated carbon filter system.
CONTROLS
The hood is equipped with a control panel with a suction speed control and a light control to light up the hob.
T1. "Night Light" ON/OFF
T2. Hob lights ON/OFF – Colour temperature selection
T3. "Autolight" operation
T4. "ZEN Mode" operation
T5. Motor ON/OFF
T6. "POWER BOOST 1" operation
T7. "POWER BOOST 2" operation
T8. "COOKSENSE" automatic operation
T9. Filter saturation indicator
T10. "Breath Daily Cycle" operating mode ON/OFF
T11. "Breath Intensive Cycle" operating mode ON/OFF
T12. WI-FI function active light indicator
T13. WI-FI connection
T1. "NIGHT LIGHT" ON/OFF
Press to switch the soft ambient lighting on/off.
T2. HOB LIGHTS ON/OFF – COLOUR TEMPERATURE SELECTION
Press to switch the hob lighting on/off
• With the lights on, touch the SL1 LED strip with your fingers to the right or left respectively to increase or decrease the
light intensity.
Press again (long press) to set the lighting colour temperature.
• Touch the SL1 LED strip with your fingers to the right or left to set a colder or warmer light colour. If there are no colour
changes for 5 seconds, SL1 flashes at the set colour level and a beep indicates that the system has saved the
configuration.
Note: the light switches to the last set colour before switch-off.
T3. "AUTOLIGHT" OPERATION
Press to activate/deactivate the "Autolight" automatic lighting function.
Note: The function is activated only when the extraction hood is connected to the hob via Wi-Fi. Once the function is
activated, the hob light will be controlled automatically depending on the status of the connected hob.
T4. "ZEN MODE" OPERATION
Press to activate/deactivate "ZEN" extraction mode.
This function activates an extraction speed that is the best compromise between silence and extraction efficiency.
T5. MOTOR ON/OFF
Press to switch the extraction motor on/off.
• With the motor on, touch the SL2 LED strip with your fingers to the right or left respectively to increase or decrease the
extraction speed (power).
T6. "POWER BOOST 1" OPERATION
With the extraction motor on, press T6 to activate the intensive extraction speed (power) "POWER BOOST 1" (timed).
Note: After 5 minutes the extraction hood will continue to operate at the previously set speed
T7. "POWER BOOST 2" OPERATION
With the extraction motor on, press T7 to activate the intensive extraction speed (power) "POWER BOOST 2" (timed).
Note: After 5 minutes the extraction hood will continue to operate at the previously set speed.
T8. "COOKSENSE" AUTOMATIC OPERATION
5