Introduction; This Manual; Cautions - Alan HP 446 Manual Del Usuario

Introduction

Congratulations on your purchase of the ALAN HP 446 extrá, an advanced
PMR446 professional radio allowing you to cover a range of up to 5-6 km.
You may use your Alan HP 446 extrá in any country where the PMR446
frequencies are authorized. Contact your dealer for further information.
Your ALAN HP 446 extrá, thanks to its rugged design will be your friendly part-
ner, even during the hardest working day, while the liquid crystal display (LCD)
and user friendly controls make it easy to use by all.

This manual

Read the instructions of this manual as well as the instruction labels on your
ALAN HP 446 extrá carefully.
Every effort has been made to ensure that the information in this document is
complete, accurate and up-to-date. CTE International accepts no responsibility
for actions resulting from errors beyond its control.
Changes made to the equipment by non-authorized personnel MAY affect the
applicability of the information contained in this document.

Cautions

Do not carry the transceiver by the antenna. This may damage
the antenna or its terminal.
While transmitting, do not hold the antenna very close to you
or allow it to touch exposed parts of the body.
Do not operate the radio near unshielded electrical blasting caps
or in an explosive atmosphere.
2
Introduction
The radio is designed to operate in harsh environmental condi-
tions. However, avoid exposing it to extreme hot or cold tempera-
tures (beyond the range -30° C to +60° C).
-30°C/+60°C
Do not expose your ALAN HP 446 extrá to excessive vibration,
dust or moisture (rain).
Do not service the radio or the batteries by yourself (other than
the routine maintenance described in this handbook).
To avoid damages on your ALAN HP 446 extrá use only ALAN
genuine accessories.
Do not use your radio near water or spill liquid of any descrip-
tion into it. If the transceiver gets wet, dry immediately with a
clean, soft cloth.
Switch the radio off before you clean it.
Be certain that your AC power source is suitable for the charger
supplied.
To avoid damaging the power cable of the battery charger, do not
put anything on it.