Publicidad
Idiomas disponibles
Idiomas disponibles
Important Safety Instructions
SAVE THESE INSTRUCTIONS
This manual contains important instructions that should be followed during the
installation, operation and storage of all Tripp Lite UPS Systems. Failure to heed
these warnings will void your warranty.
UPS Location Warnings
• The UPS is heavy. Use caution when lifting it.
• Your UPS is intended to be used in a temperature/humidity controlled environment,
indoor area that is relatively free of conductive contaminants. Install your UPS
indoors, away from excess moisture, heat, conductive contaminants, dust and direct
sunlight.
• For best performance, the ambient temperature near your UPS should be between
0° C and 40° C (between 32° F and 104° F).
• Leave adequate space around all sides of the UPS for proper ventilation. Do not
obstruct its vents or fan openings.
UPS Connection Warnings
• CAUTION: Install in accordance with National Electrical Code standards ANSI/NFPA
70 and Canadian Electrical Code, Part I, C22.1.
• Short-circuit backup protection and overcurrent protection is provided by the building
installation.
• To reduce the risk of fire, connect only to a circuit-provided branch circuit overcurrent
protection in accordance with the National Electrical Code, ANSI/NFPA 70 and the
Canadian Electrical Code, Part I, C22.1. Be sure to use maximum 20A overcurrent
protection, in accordance with the plug/equipment rating, for the installation.
• The plug on the power supply cord is intended to serve as the disconnect device.
Be sure that the socket-outlet is installed near the equipment and is made easily
accessible.
• The UPS contains its own energy source (battery). The output terminals may be live
even when the UPS is not connected to an AC supply.
• Connect your UPS to a properly grounded AC power outlet. Do not modify the UPS's
plug in a way that would eliminate the UPS's connection to ground. Do not use
adapters that eliminate the UPS's connection to ground.
• Do not plug your UPS into itself; this will damage the UPS and void your warranty.
• If you are connecting your UPS to a motor-powered AC generator, the generator must
provide filtered, frequency-regulated computer-grade output. Connecting your UPS to
a generator will void its Ultimate Lifetime Insurance.
Equipment Connection Warnings
• Use of this equipment in life support applications where failure of this equipment
can reasonably be expected to cause the failure of the life support equipment or to
significantly affect its safety or effectiveness is not recommended.
• Do not connect surge protectors or extension cords to the output of your UPS. This
might overload the UPS and will void the surge protector and UPS warranties.
2
Publicidad
