Publicidad
Idiomas disponibles
Idiomas disponibles
Quick Installation
1
Plug the UPS into a wall outlet
supplying 120V or 230V (nominal)
AC power.
Use the included detachable power cord.
The IEC-320 end connects to the AC input
receptacle on the rear of the UPS. The NEMA
5-15 end connects to the wall outlet.
To plug the UPS into a wall outlet that does
not accept a NEMA 5-15 plug, simply replace
the included power cord with a detachable cord
from another piece of equipment, such as a
computer. Then, use the included power cord to
connect the equipment to the UPS.
NOTE: After you plug the UPS into a live
AC outlet, the UPS (in "Standby"
mode) will automatically charge its
batteries,* but will not supply power
to its outlets until it is turned ON
(see Step 3 below).
* The BATTERY CHARGE LED will be the only LED
illuminated.
2
Plug your equipment into the UPS.
NOTE: Your UPS is designed to support
only electronic equipment. You will
overload the UPS if the total VA
ratings for all the equipment you
connect exceeds the UPS Output
Capacity (700VA). To find your
equipment's VA ratings, look on their
nameplates. If the equipment is
listed in amps, multiply the number
of amps by 120 to determine VA.
(Example: 1 amp × 120 = 120 VA). If you are
unsure if you have overloaded the UPS outlets, see
"OUTPUT LOAD LEVEL" LED description.
3
Turn the UPS ON.
Press and hold the "ON/OFF/STANDBY" button
for one second. The alarm will beep once briefly
after one second has passed. Release the
button.
1
2
3
4
Publicidad
