ATE 03.9314-1370.4 Manual De Instrucciones página 23

ATE Operating manual
4. Screw the plug-in nipple into the air-in
port.
5. Connect the unit to an appropriately
sized hose. Do not use damaged, worn-
out or low-quality compressed air hoses
or connectors.
4.2 Mounting the abrasive
1. Before mounting or removing the abras-
ive, disconnect the unit from the com-
pressed air supply.
2. Turn th the abrasive clockwise to mount
in on the unit. Before mounting the ab-
rasive, check that the specified max-
imum operating speed is the same as or
higher than the unit's rated speed.
4.3 Connecting the compressed air supply
1. Switch on the compressor to allow it to
fill the compressed air tank.
2. Set the compressor governor to approx.
6.2 bar (90 PSI). This tool's maximum
operating pressure is about 8 bar
(116 PSI).
4.4 Operating the unit
1. Press and hold the unit's On/Off button
(3) before letting the unit contact the
workpiece.
2. To set the speed, move the lever (1) to
somewhere between "L" and "H".
EN 23