Descargar Imprimir esta página

Kenmore 363.63672 Instrucciones De Instalación página 21

Hornos de speedcook

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation Instructions
ADAPTING
BLOWER FOR
TOP EXHAUST
(continued}
[_] Place the blower unit ]_ack into the opening.
CAUTION: Do not pull or stretch the blower unit
wiring. Make sure the wires are not pinched.
[_
Secure
blower
unit
to oven
with the
removed
screw
in Step 2. Insert
the screw in bottom
right screw
hole on the back of the oven.
Re lace
[] p
Step 1.
blower plate with the screws removed
in
= _*"_
BlowerPlate Screws
• =r-... BlowerMotor
Screw
ASSEMBLE
AND INSTALL
ADAPTER
_
-.,,t--_
Damper
t
J
__
Adapter
_
BlowerPlate
0vee
[_Place
the oven in its upright
position_ with the top
of the unit facing up.
[_ Insert the tabs on each side of the damper into the
holes at the inside rear of the adapter.
[3"] Attach the exhaust
adapter
to the blower plate with
the two bronze metal screws provided.
Make sure that the damper pivots easily before
mounting
oven.
You will need to make adjustments to assure proper
alignment
with your house exhaust
duct after the
oven is installed.
I-_
MOUNT
THE OVEN
FOR EASIER INSTALLATION AND PERSONAL
SAFETY,,WE RECOMMEND
THAT TWO PEOPLE
INSTALL THIS OVEN.
IMPORTANT:
Do not grip
or use handle
during
installation.
NOTE: If your cabinet is metal, use the nylon
grommet around the power cord hole to prevent
cutting of the cord.
NOTE: We recommend
using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT:
If filler
blocks
are not ttsed,
case damage
may occur
from
over tightening
screws.
NOTE: When mounting
the oven, thread power
cord through
hole in
bottom of top cabinet.
Keep it tight throughout
Steps 1-3. Do not pinch
cord or lift oven by
pulling cord.
[-_Lift oven, tilt it forwar_
and hook slots at back
bottom edge onto
two lower tabs of
mounting
plate.
21

Publicidad

loading