Publicidad
Idiomas disponibles
Idiomas disponibles
Preparing for a session
1.
Before first use, be sure to fully charge the Glomask (see charging section).
2.
Clean the Glomask by wiping with an antibacterial wipe or damp cloth.
3.
Wash and dry your face, ensuring any make-up has been removed.
4.
Remove the battery protection plastic liner from the remote control battery.
5.
Turn the mask on by pressing the power button on the mask. This will be
indicated by a flashing green light.
6.
Wear the mask on your face. You may need to adjust the headband and
height of the chin rest to find a comfortable fit.
Note: Glomask can be used alongside TensCare's Unigel. This contains hyaluronic
acid and can help improve the light therapy effectiveness whilst also moisturising
your skin. If using the Unigel, apply to your face before wearing the Glomask.
Completing a session
1.
Select the desired light therapy mode on the remote controller by pressing
the control button. LEDs will automatically turn on when a mode is selected.
Warning: Make sure you are wearing the mask before selecting a therapy mode.
Avoid looking directly at the LEDs. This could cause damage to your eyes.
2.
The Glomask will automatically turn off when the session is complete. This will
be indicated by two beeps.
3.
Remove the Glomask and wipe clean with an antibacterial wipe or damp
cloth.
4.
The Glomask should be stored in the travel bag between uses.
5
Publicidad
