KUKKO 69 Serie Instrucciones De Uso página 26

KUKKO tool factory
Series 69, 70, 71, K-222
Operating instructions serie 70
removal of grooved ball bearings located in a casing and, at the same time,
on a shaft (the shaft does not have to be removed).
EN
There are two different ways to pull the bearings:
using a support ring on the casing or using a slide hammer without any contact with the casing. The
bearing is NOT damaged in the process.
K-222-1/7
the following sets are available in series 70:
K-70-A
26
TIP
To access the ball bearing, it may be necessary to first
remove a cover. Use the KUKKO K-222-1/7 seal extractor
set to do so.
K-70-B
Detailed information about this tool
set is available in this instruction
manual starting on page 38.
K-70-C
A world in motion
since 1919!