Publicidad
Idiomas disponibles
Idiomas disponibles
KUKKO tool factory
Series 69, 70, 71, K-222
all tools must always be used for the intended purposes under the envisioned conditions and
within their postulated limitations.
Check the condition of your tools at regular intervals, and
replace any damaged or worn parts.
EN
Keep the threads of all pressure spindle and cross-beam
clean and well oiled.
(KUKKO special sliding grease for pressure spindle Art. 699999)
Before you start work, acquaint yourself with the proper use of
the tool or tools in question, with due attention to pertinent
safety measures.
If anything at all is unclear about any of the above, it is best
to call the factory for some firsthand advice.
O.K.
Prior to starting work, make sure that the pulling tool is in
good working order.
> 3 mm
Double-check the tool for correct mounting, and monitor the
forces incidental to the pulling process.
Never violate the maximum load data prescribed for the tool
in question. Use a torque wrench (for mechanical/pressure-
screw-driven tools) or a pressure gauge (hydraulic/pump-
driven tools) to keep tabs on the applied forces.
Always wear suitable personal protective equipment,
including protective goggles.
Always wrap the pulling tool and the workpiece in a protective
blanket as a precaution against the potential effects of
sudden release.
If the tool appears to be overloaded, works sluggishly, or
is otherwise negatively conspicuous, interrupt the pulling
process, and replace the tool with a larger model.
Never use an electric- or pneumatic-powered impact/hammer
drill for driving a pulling tool.
Never use extensions to increase the applied torque.
Never alter a pulling tool or related product in any way.
Since heat detracts from the thermal properties of steel, and
since some parts require heating to facilitate their removal,
remember to never heat the pulling tool along with the part.
42
> 3 mm
>
90°
A world in motion
since 1919!
Publicidad
