KUKKO 69 Serie Instrucciones De Uso página 36

KUKKO tool factory
Series 69, 70, 71, K-222
Ball bearing installation with a press (series K-71-W-...)
EN
36
1. The combination of impact ring and impact sleeve required for the installation
of the ball bearing can be found in the table inside the case cover. (see table page 35).
2. Put the bearing location on a solid, flat surface beneath your workshop press.
3. Place the bearing flat on the bearing location (you may need to tap the bearing
into place with light hammer blows). Position the press ram flat on the bearing.
4. Slowly increase the pressure with the workshop press.
5. Continue until the bearing is fully seated.
6. Fully pressed bearing.
A world in motion
since 1919!