IKEA VAPPEBY Manual página 10

7
1
English
1. AC IN connector.
2. Enable/disable auto-off switch.
3. Power button and Spotify Tap.
4. Bluetooth pairing button.
5. Volume control and LED status light.
6. Battery compartment lid (battery sold
separately).
7. AUDIO IN connector.
Getting started:
1. Connect mains cord into AC IN (1)
connector.
2. Long press on the ON/OFF button (3) to
turn the speaker ON. VAPPEBY 20 starts
to search for paired devices. If a paired
device is found, the LED will change
from blinking to a steady light and the
speaker is ready to use.
3. If no device is found, the LED continues
to blink and enters pairing mode
10
VAPPEBY 20 gen3 (E2036)
2
3
LED status (5)
Flashing white: Bluetooth is pairing.
Steady white: Paired to a device.
Flashing red: Low battery.
Steady red: Charging (when speaker is
off).
automatically. Go to the Bluetooth
settings of your mobile device and
connect to VAPPEBY 20 gen3. The LED
should now stop blinking and your
speaker is ready to use.
Adjusting the volume
Turn the knob (5) left to decrease or turn it
right to increase volume level.
4
5
6