cecotec READYWARM 2000 POWER CEILING Manual De Instrucciones página 48

ENGLISH
3. OPERATION
Assembly
WARNING: make sure that the heater is not lit before hanging it in a gazebo or under a balcony
or roof.
4. Make sure that hook "A" is securely attached to the heater.
5. Attach hook "B" to a secure post, beam, or any solid object. You can also hook hook "B" to
hook "A" to encircle an object and install the heater.
6. Plug the heater into a power socket.
WARNING: wait until the heating element has cooled down before moving the heater.
PLEASE NOTE: portable electric heaters are designed for spot heating or as a supplementary
-
heat source. They are not designed to be the main heating source during cold months.
Warning: if you have to use an extension cable, it must be at least 14 AWG and have a
-
power rating of not less than 1875 W.
Always ensure that there is at least 50 cm (20") of space above the heater, 25 cm (9") from
-
the side and 180 cm (5") below the heater.
Fig. 2
1. Ceiling
2. Wall
3. Floor
Operation
1. Plug in the heater and press the on/off switch. The red indicator will light up and the heater
will enter standby mode.
2. Press once. The green indicator will light up and the heater will operate at low power.
3. Press twice to select medium power.
4. Press three times to select high power.
5. Press four times to select high power and turn on the LED light.
6. Press five times to only turn on the LED light.
7. Press six times to return the heater to standby mode. The red indicator will light up.
Remote control functions
Plug in the heater and press the on/off switch on the appliance. The red indicator will light
-
up and the heater will enter standby mode.
Press the on/off switch to turn off the appliance.
-
The 800-W button is used to select low power.
-
The 1200-W button is used to select medium power.
-
Press both 800-W and 1200-W buttons to set the desired power.
-
The button is used to turn on and adjust the LED light.
-
48
READYWARM 2000 POWER CEILING