Philips ZOOM! WhiteSpeed Instrucciones De Uso página 8

8 English
5 Loosen the knobs on the side of the socket at the end of the boom 4-5 turns , then push the head into the socket.
1
2
6 Place the boom onto the stand by carefully aligning the hole in the boom with the hole in the stand.
7 Insert the screw into the hole and tighten it. Keep tightening the screw until it is completely in the pocket.
8 Connect the electrical cord of the boom to the cord of the stand and the head. Turn the head connector clockwise
1
2
9 When you are ready to test the accelerator light, switch on the device by setting the switch on the power pack to 'O'.
Accelerator light setup
Plug the power cord of the base directly into a properly-rated power outlet.
Caution: The inlet (the end of the cord) must be accessible in order to disconnect the power if a problem occurs.
The accelerator light is now ready for use with a procedure kit. Please refer to the procedure kit instructions for use for
further setup and whitening gel application instructions.
ZOOM_3000.040.0114.3_BOOKLET-lux_US-letter_FC.indd 8 ZOOM_3000.040.0114.3_BOOKLET-lux_US-letter_FC.indd 8
The screw should be flush with or inset into the pocket.
IMPORTANT: The screw has glue on the threads (yellow in color) that releases as the screw is tightened. Therefore it
is important to finish tightening the screw upon insertion or the glue may harden and stop the screw from being fully
inserted.
until you feel it lock into place.
07-05-21 09:39 07-05-21 09:39