Philips ZOOM! WhiteSpeed Instrucciones De Uso página 9

Zoom! Light Accelerated In-Office Whitening Treatment
Light guide
The light guide is designed to ensure proper distance and alignment to maintain correct light exposure on the smile
zone.
1 Remove the light guide from the procedure kit and place it on the end of the accelerator light head.
2 Switch on the accelerator light using the power button located on the side of the power pack. When the light guide is
Each new light guide is loaded with four 15-minute acceleration sessions.
Aligning the head and light guide to the retractor
1 Once the whitening gel application is complete, raise the back of the chair so the patient is in a slightly reclined
2 Slide the accelerator light into place next to the patient. The boom should be movable, but stable.
3 Grasp the accelerator light head with one hand and bring it close to the patient's mouth. Use your other hand to
4 Use both hands to finalize positioning of the accelerator light head so the light guide and IsoPrep retractor
5 Tighten the head and boom knobs.
6 Lock the casters in position. While engaged, the light guide and IsoPrep retractor will allow the accelerator
Running a whitening procedure cycle
Each treatment consists of three 15-minute whitening sessions with a pause after each session to allow the dental
professional to remove and replace the whitening gel. Each light guide includes a fourth session for use on patients
with shades A3 or darker.
1 Ensure the patient is properly prepared according to the procedure kit instructions for use and that all protective
2 Press the 'Intensity' button to toggle between high, medium, and low light intensities until the desired intensity is
3 Press the 'Start' button to switch on the light and activate the session timer.
4 Inform the patient that the progress of each session is tracked by four white lights on top of the accelerator light
5 Once the light is on, a countdown is displayed. The accelerator light beeps once when three minutes of the session
6 If a session must be interrupted, press the 'Pause' button. The remaining session time flashes on the display. To
7 At the end of each 15-minute session, the display indicates the number of remaining sessions left on the light guide.
8 When all sessions on a light guide are finished, the display reads 'Sessions Complete' for three seconds, followed by
ZOOM_3000.040.0114.3_BOOKLET-lux_US-letter_FC.indd 9 ZOOM_3000.040.0114.3_BOOKLET-lux_US-letter_FC.indd 9
properly attached, the power pack display will read 'Guide Status-Guide Attached' followed by ' X of X Sessions'.
position (~45 degree angle) and able to swallow comfortably while maintaining light pressure on the bite block.
See the procedure kit instructions for use for whitening gel application instructions.
lift or lower the boom as needed to make sure the accelerator light head is aimed directly at the patient's teeth.
(included in procedure kit) slots are aligned.
light head to follow minor movements of the patient's head to ensure proper alignment.
barriers are in place.
selected. This setting can be changed at any time during the whitening procedure.
Tip: Use the high setting for maximum whitening and the low setting for maximum heat and sensitivity management.
Note: Lower light intensity may reduce results.
head. Each light indicates one quarter of a session.
are remaining and beeps three times in the final three seconds of the 15-minute session. When the session is
finished, the light goes out and you hear a long beep.
reactivate the session, press either the 'Pause' or 'Start' button.
DO NOT PRESS THE 'STOP' BUTTON AT ANY TIME DURING THIS PROCESS OR AN ENTIRE 15-MINUTE SESSION
WILL BE LOST.
Press 'Start' to activate the light for the next session.
'Guide Status – Replace Guide'. Detach the light guide from the IsoPrep retractor and pull the accelerator light away
from the patient.
Tip: After each session, make sure the patient's lips and gums are consistently and thoroughly covered to help
prevent any exposure of soft tissue to the LED lights and whitening gel.
English 9
07-05-21 09:39 07-05-21 09:39