Publicidad
Idiomas disponibles
Idiomas disponibles
MENU
Programming Your Remote
APPS
OK
Sleep
Setup
1
2
4
5
7
8
0
MENU
MENU
MENU
1
Sleep
4
1
7
4
7
1
4
SRP8121G_27 EnSp manual v1.indd 8
SRP8121G_27 EnSp manual v1.indd 8
1.
Manually turn on the device you
wish to control.
NOTE: The Auto Code Search process
cannot be used for devices without
power ON/OFF capability. Use the
Direct Code Entry method in these
cases.
2. Press and hold down the Setup
button on the remote until the red
light on the remote control turns on.
ch
Release the Setup button. The red
light will remain on.
3
NOTE: The red light will either be a
small light at the top of the remote or
6
the power ON/OFF button.
INPUT
3. Press and release the device button
9
on the remote for the type of device
you wish to control, (for example
ENTER
tv, strm, aud, etc). The red light will
blink once and remain on.
4. With the remote pointed at the
device, press and release the Power
button on the remote. The remote
INPUT
will send 10 different codes to the
INPUT
device. The red light will blink once
APPS
for each code and remain on after
sending the 10 codes.
Did the device turn off?
• If YES, go to Step 5.
• If NO, repeat Step 4 to test the
APPS
OK
next 10 codes.
5. Manually turn the device back on.
APPS
6. With the remote pointed at the
device, press and release the
OK
VOL+ button. The remote will re-
Sleep
Setup
ch
send the first code of the 10 codes
from Step 4. The red light will blink
2
3
once and remain on.
OK
Setup
ch
Did the device turn off?
5
6
2
3
• If YES, you have found a code for
the device. Press and release the
8
9
5
6
same device button you pressed
in Step 3. This will store the code
8
9
0
in the remote. Go to Step 7.
ENTER
Sleep
Setup
ch
0
ENTER
2
3
5
6
8
5/24/21 6:21 PM
5/24/21 6:21 PM
Publicidad
