Publicidad
Idiomas disponibles
Idiomas disponibles
Programming Your Remote
MENU
MENU
Controlling Combo Devices
Some combo devices (e.g. TV/VCR, TV/DVD,
DVD/VCR, etc.) will require you to set up two
different device buttons to control both parts
MENU
of the combo device. For example, if you have
a TV/DVD combo, you may need to set up one
code under the tv button to control the TV
and a separate code under the b-ray button
to control the DVD.
1
4
SRP8121G_27 EnSp manual v1.indd 9
SRP8121G_27 EnSp manual v1.indd 9
INPUT
APPS
• If NO, continue to press and
release the VOL+ button until
the device turns off to test the
other 9 codes from Step 4. Be
sure to wait approximately 3
seconds after each VOL+ button
OK
press to allow the device time
APPS
to respond to the code. When
the device turns off, you have
found a code for your device.
Press and release the same
device button pressed in Step
Sleep
Setup
3. This will store the code in the
OK
remote. Go to Step 7.
1
2
NOTE:
4
5
• The
go backwards through each batch
of 10 codes.
8
7
• The red indicator light will flash 2
Sleep
Setup
times after testing the first or last
0
ENTER
1
2
code in each batch of 10.
7.
Use the remote to turn the device
4
5
back on. Test the buttons on
the remote to see if the device
responds as you would expect.
8
7
If the buttons do not operate the
device, return to Step 2 and repeat
0
ENTER
this process to search for a better
code to operate the device.
8. Repeat this process for each
INPUT
device you wish to control.
APPS
OK
Sleep
Setup
ch
2
3
5
6
ch
3
VOL-
6
button can be used to
9
ch
3
6
9
9
5/24/21 6:21 PM
5/24/21 6:21 PM
Publicidad
