Publicidad
Idiomas disponibles
Idiomas disponibles
6. ADJUSTING
THE LASER LINE
NOTE: Laser pointer (1) is an alternative part. Your
machine may not have this laser pointer.
How to check and adjust the Laser Beam Alignment:
Check the laser beam alignment to ensure the intersec-
tion of the laser lines precisely at the spot
where the drill bit meets the workpiece. If it is not,
the laser lines should be adjusted using the laser ad-
justment knobs located on the opposite sides of
the head assembly. See Fig. 16
1. Mark an "X" on a piece of scrap wood.
2. Insert a small drill bit into the chuck and align its tip to
the intersection of the lines of the "X".
3. Secure the board to the table.
4. Turn on the laser switch(3) and verify the laser lines
align with the "X" on the workpiece.
5. If the laser lines do not align, loosen knobs(2) on each
side of the laser module and rotate the lasers(4) until
the lines meet in the center of the "X". Retighten the
knobs to secure.
NOTE: Check and adjust the laser beam alignment every
time the drill _ress table is raised or lowered to a new
position.
CD
WARNING!
LASER RADIATION: AVOID DIRECT EYE CONTACT
• A Laser light is radiated when the laser guide is turned
on. Avoid direct eye contact. Always turn off the laser
and unplug the drill press from the power source be-
fore making any adjustments.
• A laser pointer is not a toy and should not come into
hands of children. Misuse of this appliance can lead to
irreparable eye injuries.
• DO NOT attempt to make any adjustments to increase
the laser power.
ADJUSTMENT/OPERATION
• When using the laser pointer, do not point the laser beam
towards people and / or reflecting surfaces. Even a laser
beam of lower intensity may cause eye damage. There
fore, do not look directly into the laser beam.
• If the laser pointer is stored for more than three months
without use, please remove the batteries to avoid dam-
age from possibly leaking batteries.
• The laser pointer includes no user serviceable compo-
nents. Never open the housing for repair or adjustments.
• On units equipped with the Laser-Guide attachment,
repairs must be performed only by a Sears or other
qualified service dealer.
12
Publicidad
