Timken VHIN-G2-10 Manual Del Usuario página 12

4. INSTALLATION
•
Remove the packaging and place the induction heater on a non-ferrous, stable and level
surface. Put heaters with wheels on the brake to prevent the heaters from moving.
•
A Timken heater is supplied with yokes, temperature sensor, heat-resistant gloves (suitable up
to 250°C / 482°F) and acid-free grease.
•
Check the connection voltage against the rating plate on the unit.
•
Each heater is equipped with a plug. As there is a wide variety of plug types, the provided
plug may not fit. In such cases, obtain a proper plug. It must be fitted by a qualified electrician.
There are different fitting options depending on the type of cable on the heater:
Fitting options VHIN-G2-10, VHIN-G2-35, VHIS-G2-75 and VHIS-G2-100
120V/230V 1 phase heaters
Brown
Blue
Green/Yellow
Fitting options VHIS-G2-150, VHIS-G2-200, VHIS-G2-400, VHIN-G2-600 and VHIN-G2-800
400V/450V/500V 2 phase heaters
Brown
Black
Green/Yellow
•
Ensure that the power supply cable cannot come into contact with the workpiece to be
heated. Insert the plug in a grounded socket outlet with connection.
•
Switch on the device by means of the main switch. The machine briefly shows "Test", and the
display shows a "pre-set end temperature" programmed by the manufacturer.
•
Connect the temperature sensor by inserting the plug into the socket. Make sure that the –
and + of the plug correspond to that of the socket.
•
The induction heater is now ready for use in the temperature mode.
12
120V/240V 1 phase heaters
Phase
Zero
Ground
480V/600V 2 phase heaters
Phase
Phase
Ground
Black Phase
White Zero
Green Ground
Black Phase
Black Phase
Green Ground