Timken VHIN-G2-10 Manual Del Usuario página 14

6. THE MAGNETIC TEMPERATURE SENSOR
•
The temperature sensor comes with the heater
and can be reordered as spare part.
•
The magnetic temperature sensor must always
be used when heating in "temperature mode".
•
The sensor can be used as a tool for temperature control whilst heating in "time mode".
•
The sensor is suitable for a maximum temperature of 240ºC (464°F).
•
In the event of temperatures exceeding 240ºC (464°F), the connection between the
magnet and the sensor is interrupted. The heater switches off automatically when
the sensor does not detect a temperature increase.
•
Special clamp sensors are available for non-magnetic workpieces.
•
Make sure that the sensor and workpiece surfaces are clean.
•
Always place the sensor on a flat area as close as possible to the bore. Connect the sensor
by inserting the plug into the socket (in the casing). Make sure that the – and + of the plug
correspond to that of the socket.
NOTE!
•
Handle the sensor with care! It is a vulnerable part of the heater. After use, place the sensor on
the side of a vertical pole. Remove the sensor from the workpiece at the plastic part. Do not
pull the cable.
14