Assembly; Technology™ System - Bosch GTS1041A Instrucciones De Funcionamiento

SETTING / RESETTING THE ACTIVE
RESPONSE TECHNOLOGY™ INJURY
MITIGATION SYSTEM
To prevent personal injury,
always disconnect the plug
from the power source before making any ad-
justments.
The Active Response Technology™ system pre-
vents the motor from restarting if the switch is on
when the plug is connected to a power source.
Automatic restart protection helps prevent acci-
dental startups after power has been interrupted,
e.g. the tool was unplugged with the power switch
locked in the ON position. To resume operation,
turn power switch to the OFF position, then re-
start the tool.
DISASSEMBLE
1. Turn elevation wheel clockwise until the blade
is up as high as it will go, remove any parts of
the Smart Guard system that were in use, then
remove table insert 21 by rotating the table in-
sert lock 22, and use the front edge (Fig. 4) to
lift clear off the table.
2. Ensure the riving knife 35 is set below the top
position. Lower the riving knife by loosening the
riving knife release lever 37 (Fig. 5). For more
information see "POSITIONING THE RIVING
KNIFE" section on page 15.
REPLACE CARTRIDGE
3. Using the activation cartridge installation tool
loosen the activation cartridge retainer 33
counterclockwise then continue to unscrew the
activation cartridge retainer by hand until it is
free on the wire. Slide along the wire to the rear
of the saw near the riving knife (Fig. 6).
1600A009XC 09-15.indb 13

Assembly

Fig. 4
21
B
Fig. 5
Fig. 6
13
21A
22
A
D
35
37
C
33
F
E
9/14/15 1:51 PM