Unpacking And Checking Contents - Bosch GTS1041A Instrucciones De Funcionamiento

To avoid injury from unex-
pected starting or electrical
shock during unpacking and setting up, do not
plug the power cord into a source of power.
This cord must remain unplugged whenever you
are working on the table saw.
Model GTS1041A Table Saw is shipped complete
in one carton.
Separate all parts from packing materials and
check each one with the illustration and the list
of loose parts to make certain all items are ac-
counted for before discarding any packing material
(Fig. 3a).
If any parts are missing, do
not attempt to assemble the
table saw, plug in the power cord or turn the
switch on until the missing parts are obtained
and are installed correctly.
TABLE OF LOOSE PARTS (Fig. 3a)
ITEM DESCRIPTION
Table Saw
1
Rip Fence
2
Table Insert
3
Barrier Guard Assembly
4
Anti-Kickback Pawls
5
Miter Gauge
6
Push Stick
7
Activation Cartridge
8
Blade, 10", 40 Tooth
9
10 Blade Wrench
11 Activation Cartridge Installation Tool
12 Hex Wrench / Philips Screwdriver
13 Manual
• Remove Styrofoam block A (for shipping pur-
pose only) located between the table and motor
(Fig. 3b). Styrofoam block B (not shown) is located
between the drop arm and throat plate. It needs to
be removed to enable the tool for it's first use. You
may cause damage to the table saw's mechanical
systems if the Styrofoam is not removed.
• Cut the cable tie that holds the drop arm dur-
ing transportation using scissors or wire cutters as
shown (Fig. 3c). Then pull the cable tie out and
discard.
1600A009XC 09-15.indb 12

Unpacking And Checking Contents

QTY.
1
1
1
1
1
1
1
1
1
1
1
1
1
Fig. 3a
5
3
6
10
11
12
Fig. 3b
Fig. 3c
12
4
2
1
7
9
8
13
9/14/15 1:51 PM
A