Bosch GTS1041A Instrucciones De Funcionamiento página 46

Problem
Saw will not start, Green Light
turns off and Blue Light turns
on.
Saw will not start (red light
flashing). If not fixed after 5 at-
tempts at turning saw on: saw
will not start and Flashing Red
light turns to Solid Blue.
Saw will not start, or saw
turns off after 3 seconds.
Saw will not start
1600A009XC 09-15.indb 46
Cause
Arbor Lock did not dis-
engage during blade
change.
Bypass switch stuck in
"ON" position.
Low or loss of voltage.
System has detected
other problem.
25 system activations
have occurred.
46
Corrective Action
Unplug tool and disengage Arbor
Lock. Ensure blade spins freely.
Turn the power switch off. Make
sure the bypass switch is not stuck
in the "ON" position.
Reduce length of extension cord to
match length of cord to gauge of
wire. See page 6.
Contact your electric company.
If using generator, check output
voltage.
The Active Response Technology
System™ has detected a problem
that requires a service technician to
service. Please bring the saw to an
Authorized Bosch Service Center.
Take saw to Authorized Bosch
Service Center for evaluation and
factory system reset.
9/14/15 1:51 PM