Publicidad
Idiomas disponibles
Idiomas disponibles
MIX INLET BLENDER OPERATING INSTRUCTIONS
FOR 521005, 521019, 521030, & 521035
INTRODUCTION
Thank you for selecting the STOELTING MIX IN BLENDER. The direct drive design of this blender provides for
quiet, trouble free operation. The unique design of the mixing head efficiently blends products together rapidly
and gently to reduce melting and breakdown of the frozen product.
The STOELTING MIX IN BLENDER was specifically designed to blend soft-serve or dipped ice cream, ice milk,
yogurt , or custard with flavors, fruit, candy, or cookies . This blender does a superior job of mixing malts, shakes,
frappes, smoothies, and freezes.
DO NOT ATTEMPT to operate the blender until instructions and safety precautions in this manual are read
completely and are thoroughly understood. If problems develop or questions arise in connection with
installation, operation, or servicing of the machine, contact Stoelting White Glove Service at 800-319-9549.
For warranty information, visit our website at: stoeltingfoodservice.com
SAFETY PRECAUTIONS
1.
The STOELTING MIX IN BLENDER should only
be used in accordance with the procedures
outlined in this manual.
2.
The STOELTING MIX IN BLENDER comes
equipped with a grounded, three (3) prong
electrical plug. DO NOT remove the grounding
prong. If the electrical outlets in your location do
not accept the 3-prong plug, an electrician must
change the receptacle to accommodate the
plug.
3.
Blenders with a foot switch are specifically
designed for use only with the STOELTING MIX
IN BLENDER. The foot switch should not be
used for any other purpose. Safe and reliable
operation is dependent upon keeping the switch
DRY and CLEAN at all times. Any evidence that
indicates that the foot switch has been wet or
dirty voids the warranty.
4.
The STOELTING MIX IN BLENDER has a very
powerful high torque motor and the mixing head
and shaft rotate at a very high rate of speed.
DO NOT ATTEMPT TO HOLD THE SHAFT OR
MIXING HEAD.
5.
DO NOT allow any foreign objects (such as
loose clothing, cleaning cloths, fingers or
jewelry) to come in contact with rotating parts.
Personal injury or damage to the blender could
result. Always disconnect the electrical power
before cleaning or maintaining the STOELTING
MIX IN BLENDER.
Owner's Manual #513738
6.
The STOELTING MIX IN BLENDER is fuse
protected. If a fuse replacement is required,
REPLACE ONLY WITH THE SPECIFIED FUSE:
•
BUSS AGC 5 Amp, 250-VOLT
DO NOT SUBSTITUTE WITH A SLOW BLOW
TYPE FUSE.
7.
The STOELTING MIX IN BLENDER is not
designed to chop or grind candy, cookies, or
hard ingredients. Using it for this purpose can
damage the blender or cause personal injury to
the operator.
8.
DO NOT OPERATE THE STOELTING MIX IN
BLENDER WITHOUT THE PLASTIC GUARD IN
PLACE.
9.
DO NOT attempt to make any adjustments
or perform maintenance until the STOELTING
MIX IN BLENDER has been unplugged. Any
adjustments or maintenance should only be
performed by a qualified person.
10. The STOELTING MIX IN BLENDER must be
installed to allow the operator to have access to
the electrical supply plug.
11.
Disconnect power and inspect the STOELTING
MIX IN BLENDER mixing head regularly for
sharp edges or wear. Replace a mixing head
with sharp edges or excessive wear to prevent
damage to mixing cups or personal injury.
12. Do not use harsh cleaners or abrasive scouring
pads on the STOELTING MIX IN BLENDER. Use
of these products will damage the surface finish.
3
A VOLLRATH® DIVISION
Mix Inlet Blender
Publicidad
