Descargar Imprimir esta página

Mi-T-M GEN-8000-iMM1E Manual De Instrucciones página 19

Publicidad

Idiomas disponibles

Idiomas disponibles

NOTE: Non-detergent or 2-stroke engine lubricants will dam-
age the engine and should not be used.
1. Turn the service door knob to OPEN.
2. Remove door set aside.
3. Remove the oil filler cap.
4. Add the recommended engine oil, using the funnel supplied,
5. After adding oil, install and tighten the oil filler cap, and close
the service door.
WARNING: WARNING: EXPLOSIVE FUEL! GASOLINE IS
EXTREMELY FLAMMABLE AND ITS VAPORS CAN
EXPLODE IF IGNITED.
STORE
GASOLINE
CONTAINERS, IN WELL VENTILATED, UNOCCUPIED
BUILDINGS AND AWAY FROM SPARKS OR FLAMES.
DO NOT FILL THE FUEL TANK WHILE THE ENGINE
IS HOT OR RUNNING, SINCE SPILLED FUEL COULD
IGNITE IF IT COMES IN CONTACT WITH HOT PARTS
OR SPARKS FROM IGNITION. DO NOT START THE
ENGINE NEAR SPILLED FUEL.
NEVER USE GASOLINE AS A CLEANING AGENT.
WARNING: DO NOT OVERFILL THE FUEL TANK, LEAVE
ROOM FOR THE FUEL TO EXPAND.
WARNING: MAKE SURE YOU REVIEW EACH WARNING
IN ORDER TO PREVENT FIRE HAZARD.
DO NOT REFILL TANK WHILE ENGINE IS RUNNING
OR HOT.
BEFORE FILLING FUEL, TURN THE ENGINE SWITCH
TO (STOP) POSITION.
BE CAREFUL NOT TO ADMIT DUST, DIRT, WATER OR
OTHER FOREIGN OBJECTS INTO FUEL.
WIPE OFF SPILT FUEL THOROUGHLY BEFORE
STARTING ENGINE. KEEP OPEN FLAMES AWAY.
USING FUEL STABILIZER
Fuel gets old, oxidizes, and breaks down over time. Adding a
fuel stabilizer (not included) extends the usable life of fuel and
helps prevent deposits from forming that can clog the fuel sys-
tem. Follow fuel stabilizer manufacturer's directions for correct
ratio of stabilizer to fuel.
1. Mix fuel stabilizer and gasoline prior to filling the tank by using
a gas can or other approved fuel container and shaking gently
to combine.
NOTE: To control the amount of fuel stabilizer being added to
the engine, always mix fuel stabilizer with gasoline before
fueling the tank rather than adding fuel stabilizer directly
into the generator's fuel tank.
2. Replace and secure the fuel tank cap.
3. Start and run the engine for at least 5 minutes to allow stabilizer
to treat the entire fuel system.
Operator's Manual
PREPARING THE GENERATOR
ONLY
IN
APPROVED
Recommended Lubricant Viscosities for Ambient
Temperature
°C
Oil Viscosities
Min
SAE 0W-40
-40
SAE 5W-40
-30
SAE 10W-30 -
18
SAE 15W-40
-10
°F
Max
Min
Max
40
-40
104
50
-22
122
40
0
104
50
14
122
19

Publicidad

loading