Makita DTW1001 Manual De Instrucciones página 8

Electric brake
This tool is equipped with an electric brake. If the tool
consistently fails to quickly stop after the switch trigger is
released, have the tool serviced at a Makita service center.
Lighting up the front lamp
CAUTION:
Do not look in the light or see the
source of light directly.
To turn on the lamp status, press the button
one second. To turn off the lamp status, press the but-
ton for one second again.
With the lamp status ON, pull the switch trigger to turn on
the lamp. To turn off, release it. The lamp goes out approx-
imately 10 seconds after releasing the switch trigger.
With the lamp status OFF, the lamp does not turn on
even if pulling the trigger.
► Fig.4: 1. Lamp
► Fig.5: 1. Button
NOTE: To confirm the lamp status, pull the trigger. When the
lamp lights up by pulling the switch trigger, the lamp status is
ON. When the lamp does not come on, the lamp status is OFF.
NOTE: When the tool is overheated, the light flashes
for one minute, and then the LED display goes off. In
this case, cool down the tool before operating again.
NOTE: Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
NOTE: While pulling the switch trigger, the lamp
status cannot be changed.
NOTE: For approximately 10 seconds after releasing
the switch trigger, the lamp status can be changed.
Changing the impact force
You can change the impact in three steps: hard, medium and soft mode.
This allows a tightening suitable to the work.
Every time the button
You can change the impact force within approximately one minute after releasing the switch trigger.
► Fig.7: 1. Changed in three steps 2. Hard 3. Medium
4. Soft 5. Button
Specifications of each impact force grade
Impact force grade displayed
on panel
Hard
Medium
Soft
for
is pressed, the number of blows changes in three steps.
DTW1001 / DTW1002 /
DTW1001XV DTW1002XV
-1
2,200 min (/min)
Reversing switch action
CAUTION:
rotation before operation.
CAUTION:
the tool comes to a complete stop. Changing the
direction of rotation before the tool stops may dam-
age the tool.
CAUTION:
always set the reversing switch lever to the neu-
tral position.
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the
A side for clockwise rotation or from the B side for coun-
terclockwise rotation.
When the reversing switch lever is in the neutral posi-
tion, the switch trigger cannot be pulled.
► Fig.6: 1. Reversing switch lever
Maximum blows
DTW1004 /
DTW1004XV
-1
2,400 min (/min) 2,200 min
-1
2,000 min (/min)
-1
1,800 min (/min)
8 ENGLISH
Always check the direction of
Use the reversing switch only after
When not operating the tool,
Application
DTW800 /
DTW800XV
-1
(/min) Tightening when force and speed
are desired.
Tightening when you need good
controlled power.
Tightening when you need fine
adjustment with small diameter
bolt.