Publicidad
Idiomas disponibles
Idiomas disponibles
GB
FISH MARKETING
The Vacuum Sealer won't turn on
• Ensure that the machine is properly plugged into a grounded outlet.
• Check the power cord for tears and frays. Do not use machine if power cord
is damaged.
The Vacuum Sealer doesn't pull a complete vacuum with bags
• To vacuum and seal properly, edge of bag must be across the seal bar. Make sure bag
is inside the chamber seal gasket and that there are no wrinkles in the bag along the
seal bar.
• If packaging from a roll bag, make sure first seal is complete and that there are no
gaps in either seal.
• The Vacuum Sealer and vacuum bag need to be clean, dry and free of debris for the va-
cuum process to be successful. Wipe surface of seal bar and inside of bag and try again.
Vacuum bag loses vacuum after being sealed
• Sharp items can puncture small holes in bags. To prevent this, cover sharp edges with
paper towel and vacuum in a new bag.
• Some fruits and vegetables can release gases (out-gassing) if not properly blanched or
frozen before packaging. Open bag. If you think food spoilage has begun, discard food. If
food spoilage has not yet begun, consume immediately. If in doubt, discard food.
The Vacuum Sealer is not vacuuming canisters properly
• The accessory hose may not be properly attached. Ensure the hose is completely inser-
ted into the lid of the canister and the accessory port and try again.
• Make sure the canister lid is turned to the "Vacuum" setting (In Marinate Mode to
"Open" setting).
• Leave adequate head space at the top of the canister.
• Make sure there isn't any damage to the canister and lid. Sometimes hairline cracks
can develop in canisters. When this happens the canister is no longer
air tight and should be discarded.
• Twist knob on lid of canister to make sure it is attached securely.
In seldom cases some of the programs may be error and lead to that the machi-
ne cannot work well
• Cut the electricity then re-connect it.
27
Publicidad
