Publicidad
Idiomas disponibles
Idiomas disponibles
LIGHTING, OPERATION, AND
SHUTDOWN INSTRUCTIONS
Unvented Portable Type Heaters Must Not be Exposed to Flammable
Vapors or Liquids.
1. Make sure the control knob is in the OFF position.
2. Install the one pound cylinder(s) as described on page 5.
Check for gas leaks by using a 50% soap-water solution at
the joint of the regulator and cylinder.
3. Depress and turn the control knob to the pilot position.
With the knob still depressed, rotate the knob between the OFF and
PILOT position activating the piezo igniter until the pilot fl ame ignites.
4. Continue holding the knob down in the PILOT position
for 30 seconds or until pilot fl ame holds.
5. Release the knob. The knob should return to the fully
extended position and the pilot should remain lit.
6. Turn on the burner by depressing the knob slightly and
gently turn the knob to the ON position.
LIGHTING IN WINDY AREAS
1. Position the heater such that the Pilot is opposite the direction that
the wind is coming from. See fi gure 2
2. Position your body behind the heater such that your body blocks the
wind while you are following the instructions for lighting the unit.
Fig. 1 - Model 4K Lighting Control Panel
Fig. 2 - Lighting in Windy Areas
NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
6
Publicidad
