cecotec Kiestra Track Manual De Instrucciones página 34

ENGLISH
piece missing or not in good condition, immediately contact the official Cecotec Technical
Support Service.
Box content:
Makalu Pro
-
Tool kit
-
Instruction manual
-
20 A fuse
-
Saddle and saddle post
-
Headlight (approved version)
-
Taillight (approved version)
-
Horn (approved version)
-
Speedometer (approved version)
-
Carry bag (optional)
-
Instruction manual
-
3. ASSEMBLY
Unfolding the handlebar. Fig. 3
The vehicle is delivered folded and with the handlebars removed.
1
First, unscrew washer 1 and remove screw 2.
2
Position the handlebar and insert screw 2 with locknut 1.
3
To place the handlebar stem properly in position, raise the handlebar and press closing
4
spring 3.
Insert the locking lever into the corresponding slot and turn until properly locked.
5
NOTE: to fold the handlebar again, follow the reverse the procedure.
Assembling the handlebar grips. Fig. 4-5
With the handlebar upright, the grips will remain suspended as shown in Figure 4.
Take the left grip and pull it upwards until pushed into position.
1
Repeat the above step with the right grip.
2
Adjusting the handlebar height. Fig. 6
Turn the adjustment knob counterclockwise and adjust the handlebar to the desired height.
1
Once set to the desired height, turn the adjustment knob clockwise to lock it in place. Make
2
sure the handlebar is firmly fixed.
Battery and motor
Both the battery and the motor come already installed and connected. To access any of these
parts, lift the deck. To activate the electrical circuit, install the fuse provided.
66
Installing the saddle. Fig. 7
Insert the saddle into the saddle post fitting it snugly into the groove.
1
Screw the saddle in position on each side until completely fixed.
2
Adjusting the height of the saddle
To adjust the saddle height, unlock lever 1 and lower or raise the saddle to the desired position.
Once the saddle is set to the desired height, lock lever 1 again.
Adjusting the front and rear brakes. Fig. 8
Both brakes require periodic adjustment.
-
The brakes should be about 5-6 mm away from the handlebar grip.
-
Stand on the vehicle to check the distance between the handlebar grip and the brake. If the
-
brakes exceed the recommended distance, turn the brake washer (A) to adjust it.
To adjust the brake cable tension, adjust the screw (B) on the rear wheel. This will allow the
-
wheel to turn easily when the brake is not being used and will also immediately bring the
vehicle to a stop when the brake lever is pressed.
WARNING: after each adjustment, tighten the locknut.
Vehicle approval
To register this vehicle for use in public spaces, you must:
Consult the legal regulations in force in your region.
-
Carry out the assembly described below.
-
Contact movilidadelectrica@cecotec.es and provide the following information:
-
Full name of the vehicle owner.
-
ID of the vehicle owner.
-
Chassis number located on the plate riveted to the chassis on the right side of the
-
latter and laser engraved on the left side.
Purchase invoice.
-
When driving your vehicle in public areas, we recommend you consult the legal regulations in
force in your region and carry the following documents:
ID
-
Warranty
-
Technical data sheet
-
Road tax
-
Registration certificate
-
Assembling the approval kit.
Parts and components. Fig. 9
Saddle post
1
Saddle
2
ENGLISH
MAKALU PRO 67