Publicidad
ee
Care and Maintenance
When servicing the air conditioner, be sure to
turn the SELECTOR switch to the "OFF"
position and disconnect the power cord from
the electrical outlet.
1. DO NOT use gasoline, benzine, thinner or other
chemicals on the air conditioner as these
substances may cause damage to the paint
finish and deformation of plastic parts.
2. Never attempt to clean the unit by pouring water
directly on it as this will cause deterioration of
the electrical insulation.
Cleaning the Air Filter
Removal of Air Filter
If the air filter becomes clogged with dust, air flow is
obstructed and reduces efficiency. The air filter
should be cleaned every two weeks.
1. Grasp the air filter tab. See Fig. 14.
2. Pull filter up. (there may be slight resistance)
Air Filter Tab
DO NOT forget to install the air filter. If the air
conditioner is left to operate without an air filter,
dust is not removed from the room air and may
result in machine failure.
When the air inlet grill and cabinet are dirty, wipe
with lukewarm water (below 40°C).
Use of a mild
detergent is recommended.
Cleaning the Air Filter
1. You can remove the dust clogged in the filter by
tapping it or vacuum clean it.
2. Wash the filter well with lukewarm water at 40°C
(104°F) while rubbing lightly: To get better
results, wash it with soapy water or a neutral
cleaning agent.
3. Rinse the filter well using clean water then
dry completely.
Attaching the Air Filter
1. Hold the air filter with front facing you
and insert it into the filter slot until it
stops completely.
End-of-Season Care
1. Operate the fan alone for half a day to dry out the
inside of the unit.
2. Turn off power and remove plug from wall socket.
3. Clean filter.
NOTE:
When cooling season is over, and the unit
is removed from window for cleaning and storage,
there still may be some condensation water in the
basepan.
Remove the unit carefully to avoid spills
on your floor. Always store unit flat on its base.
Be
sure
to remove "L" bracket, sash bracket, and
foam seal from the window and save. Window will
not close if sill bracket remains installed.
Beginning-of-Season Care
1. Clean filter.
2. Test run for 5 minutes.
3. Wait 3 minutes before starting
fan/cooling operation.
10
à
Publicidad
