• The product must not be charged over extended periods.
• Always keep an eye on the device throughout the charging cycle.
• Charge the device only at temperatures between 0 °C and +45 °C.
• When charging at lower or higher temperatures, there is a risk that the battery performance will be
reduced; therefore, there is a potential risk of injuries and material damage.
• Store and charge the device in an open, dry area away from combustible materials.
• Do not charge the device in direct sunlight or in the vicinity of open flames.
• Do not charge the device immediately after use. Allow the device to cool down for an hour before
charging it.
• If the device is left to other people, it must be charged partially (20 - 50%), not fully.
• Do not remove the device from its package to fully charge it and then put it back in the package.
• The device is generally partially charged as shipped from the factory. Keep the device partially
charged until it is used.
• Allow the E-scooter to cool down for at least 1 hour before it can be put in the package.
• Do not leave the device exposed to sunlight in a car.
The E-scooter must not be used during the charging cycle!
• The LED indicator on the battery charger lights red during the charging process.
• The LED indicator on the charger will light green when the charging process is complete.
• After charging, disconnect the charger from the mains and the E-scooter.
Connect the DC cable supplied with the E-scooter only to the DC input!
• Do not insert foreign bodies into the DC input.
• Do not remove the protective cap from the DC input!
• Remove the cap only when charging the e-scooter!
• After charging, disconnect the DC plug and close the DC input again with the cap!
Make sure that neither water nor other liquids penetrate into the inner components of the E-scooter;
otherwise, the electronics/batteries of the device could be permanently damaged. There is a risk of
injury.
• If you open the E-scooter casing, the warranty will become null and void.
• Always keep the protective cap plugged onto the DC connector!
• Only take off the cap when charging the balance scooter!
• After charging finished take out the DC plug and put on the protective cap onto the DC connector
again!
• Make sure to wear helmet and protective clothing before using the E-scooter.
• Make sure to read manual carefully before using the E-scooter.
• The E-scooter is not intended for use on public roads nor in traffic
• The E-scooter must only be used on dry and level ground
• For domestic use only
•The E-scooter may not be used by anyone under age of 14 years