Permobil TiLite CR1 Instrucciones De Uso página 8

Operation Instructions, continued
Fold Down Back Support
To fold down the back support:
1. Push up on the two side guards at the cutout section along
the back edge of each side guard, located just below the rear
attachment point to the back canes.
2. Push the back support forward and the side guards will fold down
together at the same time.
2
1
Anti-Tips
To install the anti-tips:
1. Press down the exposed button on the end of the anti-tip tube and slide
into the receiver at the bottom of the camber tube vertical strut.
2. Make sure the button of the anti-tip tube pops into the hole on the receiver
and locks it into place.
Wheel Locks (includes brake extension)
The wheel locks on the CR1 come pre-installed but can be adjusted to an
individual's preference.
To adjust:
1. Loosen the adjustment screw on the wheel lock clamp.
2. Slide the lock assembly forward (less lock tension) or backwards (more
lock tension).
IMPORTANT! The effort required to engage or disengage the wheel lock is an
indication of grip strength against the wheel and the wheel lock's performance.
Also, a reduction in lock strength is likely indicates an underinflated tire with
less than optimal tire pressure.
Side Guards
The wheelchair comes with two side guards which are mandatory and cannot be removed as they are a critical frame component.
Positioning Belt
The wheelchair is available with a black nylon, hook and loop fastener adjustable positioning belt. Undo the strap and set the tension as desired.
Permobil TiLite CR1 Instructions for Use
Cutout section
Set Up Back Support
To set the back support up for use:
1. Pull back on the back crossbar until the back support is
completely up.
2. Push down on each side guard to lock the back support in place.
Back
crossbar
2
Receiver
Anti-tip Tube
Exposed Button
6
1
Adjustment
Screw